Hanger Options Datasheet

The Simpson Strong-Tie technical brochure includes full details of the hanger optiosn available, clcik below to open that section as a pdf.

Open the Hanger Options Datasheet

Options and Terminology

The following information applies only to products manufactured by Simpson Strong-Tie and installed as per our installation instructions. A qualified engineer must always evaluate each connection, including head and joist limitations.

Skewed Seat

Skewed left or right, on plan. Suitable for floor or roof members skewed at an angle to the support. Specify skew angle and direction.

Sloped Seat

Sloped up or down on plan. Suitable for roof rafters supported on ridge beam. Specifiy slope angle and up or down.

Sloped Top Flange

Top flange sloped down to the left or right. Suitable for roof member supported on main rafter. Specify slope angle to horizontal, slope down to left or right and low, centre or high side of stirrup flush with header.

Offset Top Flange

Stirrup is offset to right or left end of the top flange, as viewed from joist. Suitable for support of trimmer beams from end of main beam. Specify offset right or left.

Straddle

Two stirrups directly opposite each other. Suitable for support of joists on either side of main support beam. Specify width of support beam or wall.

Concealed Flange

SAE, HU and U hangers flanges concealed. Specify both flanges or single left or right flange concealed. For SAE minimum width
100mm, for HU & U minimum width 70mm.

Return Top Flange

Masonry JHM & HJHM hanger. Specify return R dimension.

Masonry Hangers for I-Joists

An innovate range of products including the Safety Fast hanger and the industry staple JHMI masonry hanger.

Go to the Timber Hangers for I-Joist and Metal Web Section > | Download the Catalogue Section (pdf)>

Masonry Hangers for Solid Joists

The UK's most complete range of masonry hangers - more sizes and variations than you can shake a brick at.

Go to the Timber Hangers for I-Joist and Metal Web Section > | Download the Catalogue Section (pdf)>

Timber Hangers for I-Joists and Metal Web

The house-builder's favourite range of connectors for I-Joist and Metal Web. Time saving solutions designed from the ground up to enable the construction of better, safer, code compliant structures.

Go to the Timber Hangers for I-Joist and Metal Web Section > | Download the Catalogue Section (pdf)>

Timber Hangers for Solid Joists

The industry standard JHA hanger with site adjustable height straps, the innovate new width adjustable SDE hanger and more.

Go to the Timber Hangers for I-Joist and Metal Web Section > | Download the Catalogue Section (pdf)>