Installation - Joist End Support

JES

Installation

Installation
  • Use the JES as a template to mark the cut line and fastener hole positions on the end of the I-joist as shown, ensuring that the ends are flush. Remove the JES before cutting and drilling the I-joist.
  • Cut and drill the I-joist. Use a 6mm diameter drill bit to create the holes.
  • Securely install a JES on both sides of the I-joist using the M6 x 30mm stainless steel Hex bolts and nylon washers supplied. Note the position of the lip on the JES which must be installed with the lip following the top-most edge of the adapted I-joist.
  • Position I-joist in between the existing trusses as shown, ensuring that a minimum 90mm of end bearing is achieved. Joist layouts will vary - please refer to engineer responsible for floor design.
  • Joist End Support
  • Joist End Support
  • Joist End Support
  • Joist End Support