Installation - Safety Fast Masonry Restraint Hanger For I-Joist



  • Use all specified nails.
  • Build masonry to required level, ensuring any coursing bricks or blocks are at least one course below the supporting block, and leave to cure.
  • Place the Safety Fast Restraint Hanger over the  inner leaf of block work, ensuring the bearing plate is fully located onto the top of the masonry, sitting tight against the front face and top of the block work.
  • Sit the floor joist into the masonry hanger and ensure all joists are correctly installed. The joist should be tight into the back of the hanger where possible. The maximum gap between the back of the hanger and the end of the joist is 6mm.
  • Clip the Safety Fast Mini Strap onto the restraining hooks on either side of the hanger and nail to the side face of the joist with 3.75 x 30mm square twist nails. INSTALL ONLY ONE STRAP PER HANGER.